|
Name Change KX-T 1232 |
|
|
In order to change names, it is necessary
to know the JACK number of the station. If you do not know the jack
number, go to the station. With a display phone, move memory switch to
PROGRAM, press 6 and the JACK number will be displayed. Ten Characters
Max. Example below is for the phone located at Jack 07 Station 121. Name to be entered is Bob |
|
|
KEYSTROKES |
DISPLAY READS |
| Move System Program Switch to PROGRAM. On the KX-T 1232 you will need to go to the Control Unit mounted on the wall. There is a 3-position switch on the left side of the system. Move the switch to the down position, labeled PITS | SYS PROGRAM NO > |
| Dial 604 | EXTENSION NAME |
| Press the SP-PHONE key | Jack No? > |
| Dial 07 (because this is jack 7) | 07 Not stored (or present name) |
| Dial 2 (for the B in Bob) | Display will read 2 |
| Press the AUTO ANSWER Key until |
B |
|
Press 6 (for the o in Bob) |
Display will read B2 |
|
Press the AUTO ANSWER Key until |
Bo |
| Dial 2 (for the b in Bob) | Display will read Bo2 |
|
Press the AUTO ANSWER Key until |
Bob |
|
Press STORE to save. Some older phones have a MEMORY button instead of STORE |
|
|
To program another jack, press SP-PHONE for NEXT, REDIAL for PREVIOUS or AUTO ANSWER and enter the desired jack number to go to a specific jack. To clear a name, Press TRANSFER, STORE. Press 1 for Q or Z or ! Press 0 for Space or . or , or ' or : or ; |
|
| Move System Program Switch to SET. On the KX-T 1232 you will need to go to the Control Unit mounted on the wall. There is a 3-position switch on the left side of the system. Move the switch to the middle position, labeled SET | |
| Additional characters that can be programmed in a station name | |||||||
| Press 1 | ! | ? | " | 1 | |||
| Press * | ? | + | - | + | < | > | * |
| Press # | $ | % | & | @ | ( | ) | # |
| Press 0 | (Space) | . | ' | : | ; | 0 | |